Cherry Mobile FLARE 2.0 Firmware / Stock Rom

Cherry Mobile FLARE 2.0 Firmware
Cherry Mobile FLARE 2.0 Firmware is here. This is Qualcomm Chip. It means, It doesn't use Research download or SP Flashtool in flashing. You don't need also a Pac file or scatter file. All you need is the ROM and External SD Card in Flashing.


Important to read

Flashing new firmware will delete all your user data, including contacts, messages, photos and other third party installed apps where installed and saved in internal storage. Performing backup first is highly recommended. The following are the common software problem that can be fix through flashing new firmware;
  • Infected Virus - Also known as Monkey Virus where when you connect to Internet, there is automatically download apps or some popup screen and sometimes automatically turn on WiFi or data connection without doing it. The virus will not remove though hard reset or formatting your phone. Installing new firmware is the best solution.
  • Unfortunately Error - This is when you open some apps it will popup Unfortunately, App has stopped. If cannot fixed through clearing the data, then flashing new firmware is also the solution.
  • Stuck or Hang in Logo - The reason for this is either when you install incorrect Rom. Try to hard reset first but if still stuck, then flashing firmware is also the solution
  • Too Many Pattern Attempts or forgot password - This is just an alternative solution if you cannot hard reset your android phone.
  • Dead boot - Another caused of flashing incorrect ROM will lead to dead boot. Make sure you are flashing the right ROM (Firmware) for your Phone. If you think below is the right firmware for your device then nothing to worry.
  • Boot Loop - The device keep rebooting when you turned it on, Unless your power switch has been damage, Flashing new ROM will fix it.
  • And any software problem.

Download Cherry Mobile FLARE 2.0 Firmware
Password: www.gsmsolutionph.com




How to flash Android phone using SD Card

  1.  Copy LWLZT01_2013-06-20_factory_updatezip to memory card.
  2. Turn On by Holding Volume up + power button.
  3.  Flashing Will start Automatically. Patiently wait and done.

1 comment:

  1. It doesn't work because I wiped out the entire system including the recovery mode.

    ReplyDelete